Firewall Wizards: Re: Noob stuck becomes PIX admin overnight!

["Julian M D" <julianmd () gmail com>]

Hi,

You better make sure you use the same access-list name in case you
have one for the DMZ.

If you are still confused a bit, just sanitize and paste your config here!

Cheers,


On 6/22/06, Glock, Neil <Neil.Glock () vita virginia gov> wrote:
> > I have a PIX 515E v6.3(3) and am running PDM v3.0(1)
> The PDM can cause problems so we don't use it.
>
> > I need to allow a device (IP 192.168.100.2) on the DMZ
> > interface to connect to a device (IP 192.168.10.1) on the
> > inside interface over a range of ports (14441 - 14450).
> access-list <name-of-access-list-DMZ> permit tcp host 192.168.100.2 host
> 192.168.10.1 range 14441 14450
> access-group <name-of-access-list-DMZ> in interface
> <name-of-DMZ-interface>
>
> Replace the names between "<" and ">" with names that apply to your
> configuration.  You may already have an access-group statement for your
> DMZ interface but that is what applies it to the interface!
>
> > I have the skills to modify my current config using the
> > terminal, I can remove and modify, but I don't have the
> > skills to create yet. Could anyone configure the lines that I
> > could use to allow this?
> Good luck!
> _______________________________________________
> firewall-wizards mailing list
> firewall-wizards () listserv icsalabs com
> https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards
_______________________________________________
firewall-wizards mailing list
firewall-wizards () listserv icsalabs com
https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards