Home page logo
/

nanog logo nanog mailing list archives

Re: ATM Question
From: Walter Prue <prue () ISI EDU>
Date: Fri, 6 Oct 2000 17:50:17 GMT


Richard,

Your problem sounds very much like one I have been dealing with.  You should 
try turning off caching on the ATM interface.  My guess is that your problem 
will go away.  Cisco recommended that I upgrade to a newer release so that
I could again turn on distributed route caching.

Walt

On Fri, Oct 06, 2000 at 04:50:10AM -0700, Richard Inhand wrote:
I'm currently looking into a weird problem at an ATM
peering point on the West Coast, when I ping from my
peer router to any of my peers I get some but not
total packet loss, when I ping from one router back or
use the loopback interface as source things are fine.
Whereas, with all my other ATM peering point routers,
for example at MAE-EAST I can ping my peers cleanly
from the same router. This isn't (to my knowledge)
affecting traffic just wondering why this strange
phenomenon should occur only in the one place.





  By Date           By Thread  

Current thread:
[ Nmap | Sec Tools | Mailing Lists | Site News | About/Contact | Advertising | Privacy ]