Home page logo
/

nanog logo nanog mailing list archives

RE: Cisco and Juniper Inter-Operability Issues ???
From: "Daniel Golding" <dgolding () sockeye com>
Date: Sat, 1 Sep 2001 08:05:17 -0400


The OSPF issues with Junos have been long fixed, although they were once
quite nasty.

- Daniel Golding

-----Original Message-----
From: owner-nanog () merit edu [mailto:owner-nanog () merit edu]On Behalf Of
John Kristoff
Sent: Friday, August 31, 2001 4:59 PM
To: nanog () merit edu
Subject: Re: Cisco and Juniper Inter-Operability Issues ???



Devon True wrote:
Any gotchas we should watch out for and any tips/tricks? I read the
NANOG archive and saw someone mention OSPF problems with Juniper and to
run ISIS. Is that still the case?

I haven't seen any OSPF compatibility problems, including the use of
authentication and changes in the default reference-bandwidth between
Junipers and Cisco.  Tested using JunOS 4.4 and 4.3.

As far as the OC3c goes, You may want to preconfigure all the VPIs
you'll ever have in advance if you can.  Anytime you reconfigure them,
the Juniper does a reset of the SAR to reallocate memory to the VPIs.
This will cause all your ATM circuits on that interface to bounce.

If you setup your peers under a BGP group statement, you will also need
a 'peer-as' statement at the group level.  You can give it a
bogus/private one there just to satisfy the config.  I don't think they
have fixed this wasn't fixed as of JunOS 4.4.

And finally, 'commit confirmed' is your friend.  :-)

John


  By Date           By Thread  

Current thread:
[ Nmap | Sec Tools | Mailing Lists | Site News | About/Contact | Advertising | Privacy ]