mailing list archives
Re: Problems connectivity GE on Foundry BigIron to Cisco 2950T
From: Sam Stickland <sam_ml () spacething org>
Date: Mon, 16 Jan 2006 00:24:35 +0000 (GMT Standard Time)
On Mon, 16 Jan 2006, Mark Smith wrote:
On Sun, 15 Jan 2006 23:50:07 +0000 (GMT Standard Time)
Sam Stickland <sam_ml () spacething org> wrote:
The cabling arrangement is:
Foundry -- Straight -- Patch -- Underfloor -- Patch -- Crossover -- Cisco
GBIC Cable Panel Straight Panel Cable
If I replace the final crossover cable with a straight,
Just do that ^^^ and give it a try.
If that fails I might have to dig out a non-passive 1000SX to 1000-BaseT
media convertor that's on one of the other sites and give that a try.
Btw, several people have suggested "speed nonegotiate" on the cisco speed.
This command is only supported on GBIC slots on cisco, not on fixed
1000Base-T interfaces (at least not a Sup720/WS-X6748-GE-TX).
I also found this reference about the clock signals in use on 1000Base-T:
1000BASE-T is based on synchronous transmission to facilitate the
cancelation of Echo/NEXT/FEXT interferences at the receivers. To achieve
synchronous transmission between the two PHYs at the ends of a link, a
master-slave clocking relationship is established by the PHYs. The
master-slave relationship between two stations sharing a link segment is
established during auto-negotiation. The master PHY uses an external clock
to determine the timing of transmitter and receiver operations. This
master clock is also provided to the other stations in the network. The
slave PHY recovers the clock from the received signal and uses it to
determine the timing of transmitter operations. In a typical network, the
PHY at the repeater will become the master and the PHY at the data
terminal equipment (DTE) will become the slave."
So it would appear that auto-negotiation is a requirement in 1000Base-T.
RE: Problems connectivity GE on Foundry BigIron to Cisco 2950T Farrell,Bob (Jan 15)
Re: Problems connectivity GE on Foundry BigIron to Cisco 2950T Sam Stickland (Jan 16)
RE: Problems connectivity GE on Foundry BigIron to Cisco 2950T sam_ml (Jan 16)
- RE: Problems connectivity GE on Foundry BigIron to Cisco 2950T, (continued)