Home page logo

nanog logo nanog mailing list archives

Re: can I ask mtu question
From: "Ricky Beam" <jfbeam () gmail com>
Date: Fri, 30 Jan 2009 16:33:43 -0500

On Fri, 30 Jan 2009 12:57:25 -0500, adrian kok <adriankok2000 () yahoo com hk> wrote:
What is max mtu in jumbo frame?

That depends on the hardware. I've seen gear running as low as ~8k. I'd have to consult standard, but I think the max is 10k (10240).

Keep in mind the switch is not the only device on the network with jumbo frame limits. The NICs in your servers will also have limits.

Do I need to reboot the switch to take effect after
setting up it?

Again, this depends on the system. Many accept the change immediately, while others have to rebooted or interfaces reset to effect the change.

if it doesn't need to reboot, How can I know the
switch is running fine in this mtu 9000? eg: cisco
any tools to check?

"ping" will do. Set the packet size larger than the normal MTU (1500) and see if it crosses the network intact. If it's not working, A) the packets will be dropped, and B) the "oversized frame" counter (among others) should be clocking errors.


  By Date           By Thread  

Current thread:
[ Nmap | Sec Tools | Mailing Lists | Site News | About/Contact | Advertising | Privacy ]