Home page logo
/

nmap-dev logo Nmap Development mailing list archives

Re: No output from --script-trace
From: Djalal Harouni <tixxdz () opendz org>
Date: Wed, 9 Nov 2011 11:48:47 +0100

On Tue, Nov 08, 2011 at 06:24:13PM +0100, Snurre wrote:
Thanks, good to know. I was under the impression that nmap would do
only what the script said it would do. Is there no option to turn 
off  "pre-scanning"?
The "pre-scanning" phase should not run by default, you can see the list
of scripts that are running in this phase, just specify -d1 or higher.

Most of the pre-scanning scripts need a special argument to run, or you
can specify "--script 'broadcast'" to start the broadcast scripts of the
pre-scanning phase.

You can find the list of the scripts that are running in the
pre-scanning phase after the following debug message (-d1):

NSE: Script Pre-scanning.
NSE: Starting runlevel 1 (of 1) scan.
...

-- 
tixxdz
http://opendz.org
_______________________________________________
Sent through the nmap-dev mailing list
http://cgi.insecure.org/mailman/listinfo/nmap-dev
Archived at http://seclists.org/nmap-dev/


  By Date           By Thread  

Current thread:
[ Nmap | Sec Tools | Mailing Lists | Site News | About/Contact | Advertising | Privacy ]
AlienVault