Firewall Wizards mailing list archives
Re: NAT on router vs. firewall
From: Neil Pike <NeilPike () compuserve com>
Date: Wed, 15 Jul 1998 03:45:21 -0400
<< From: Bill_Royds () pch gc ca
How would you implement rules on firewall based on source address or
destination address?. The firewall would only see the NAT versions of
IP
numbers so would not have any basis other than port to filter.
781.321.6000 >>
Yes, the firewall only needs to see NAT'd addresses, but usually you
have a one to one mapping for destination addresses inside your
network, therefore you can apply rules just as tightly. For traffic
coming in from outside (e.g. the internet) usually you're not going to
know the source address anyway, so I find it easier to translate these
to a pool of NAT'd addresses so that the firewall then knows that
anything coming in from 40.10.10.x (say) is actually an Internet
address.
Neil Pike MVP/MCSE
Protech Computing Ltd
Current thread:
- NAT on router vs. firewall Gregory Blake (Jul 12)
- <Possible follow-ups>
- Re: NAT on router vs. firewall Bill_Royds (Jul 14)
- Re: NAT on router vs. firewall Neil Pike (Jul 14)
- Re: NAT on router vs. firewall Neil Pike (Jul 15)
- Re: NAT on router vs. firewall Bill_Royds (Jul 15)
- Re: NAT on router vs. firewall Neil Pike (Jul 17)
- Re: NAT on router vs. firewall Bill_Royds (Jul 19)
