Firewall Wizards mailing list archives
RE: PIX firewall global command
From: Rudy_D_Pereda () mail dbf state fl us
Date: Fri, 9 Nov 2001 13:40:19 -0500
I appreciate the quick response very much. I also found out that the
version of software I'm running does not support multiple global statements
per interface. I'm running PIX version 4.4 and the versions that support
multiple global statements start at version 5.2.
At any rate, I appreciate the explanation.
...Rudy.
Jonathan
Rozes To: "'Rudy_D_Pereda () mail dbf state fl us'" <Rudy_D_Pereda () mail dbf
state fl us>,
<jrozes@vinto firewall-wizards () nfr com
n.com> cc:
Subject: RE: [fw-wiz] PIX firewall global command
11/09/2001
12:08 PM
Hi Rudy,
I'm not entirely sure of the topology you are describing - do you have two
networks behind your PIX that each need to access remote sites through the
outside interface using different nat addresses? In any case, the global
and
nat commands work together with a nat id. Let's say you want the systems on
the network 10.1.1/24 to use the nat address 10.4.4.4 and the systems on
network 10.1.2/24 to use the nat address 10.4.4.5. You should be able to do
that like this:
global (outside) 1 10.4.4.4 netmask 255.255.255.0
global (outside) 2 10.4.4.5 netmask 255.255.255.0
nat (inside) 1 10.1.1.0 255.255.255.0 0 0
nat (inside) 2 10.1.2.0 255.255.255.0 0 0
The nat ids are specified in the third field of each command (I used 1 and
2
above). Nat ids can be any positive integer between 0 and 2 billion. Beware
that id 0 has a special meaning though - it specifies addresses that should
be exempted from translation. Access control would still be accomplished by
applying access lists to specific interfaces.
Hope this helps...
jonathan
+++ Jonathan Rozes, Systems Architect, Will Vinton Studios
-----Original Message----- From: Rudy_D_Pereda () mail dbf state fl us [mailto:Rudy_D_Pereda () mail dbf state fl us] Sent: Thursday, November 08, 2001 6:54 AM To: firewall-wizards () nfr com Subject: [fw-wiz] PIX firewall global command I have two different groups that need access to a secured site. I've been given two IP addresses to use for translation. My question is: How can I setup two global statements with different Nat IDs to allow the different groups access to specific systems on the secured site using the given IP addresses? By the way, the groups are located in different geographic regions and all must come across a frame-relay network. Any help will be highly appreciated. ...Rudy Pereda _______________________________________________ firewall-wizards mailing list firewall-wizards () nfr com http://list.nfr.com/mailman/listinfo/firewall-wizards
_______________________________________________ firewall-wizards mailing list firewall-wizards () nfr com http://list.nfr.com/mailman/listinfo/firewall-wizards
Current thread:
- PIX firewall global command Rudy_D_Pereda (Nov 09)
- <Possible follow-ups>
- RE: PIX firewall global command Jonathan Rozes (Nov 10)
- RE: PIX firewall global command Rudy_D_Pereda (Nov 10)
