Firewall Wizards mailing list archives
RE: help...
From: "Claussen, Ken" <Ken () kccweb com>
Date: Wed, 19 Feb 2003 07:21:14 -0500
You want to employ a technique called "Identity NAT" (Search Cisco for more info). It looks like in versions prior to 5.3 you must configure it as Nat 0. nat [(if_name)] 0 local_ip [netmask [max_conns [em_limit]]] [norandomseq] If your DMZ network was 192.168.225.0 255.255.255.0 then the command could look like(With unrestricted Max Connections and no Embryonic Limit), NAT DMZ 0 192.168.225.0 255.255.255.0 0 0 http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_r eference_chapter09186a00800ec9e9.html#xtocid4 (Watch Word Wrap). The docs I read said this should be backwords compatible, but you might want to check the NAT command syntax for your version specifically. This statement allows the Hosts in the DMZ to talk to the inside with their given IP address. Ken Claussen MCSE(NT42K) CCNA CCA "In Theory it should work as you describe, but the difference between theory and reality is the truth! For this we all strive" -----Original Message----- From: michael [mailto:madams () humanfactors com] Sent: Monday, February 17, 2003 2:04 PM To: firewall-wizards () honor icsalabs com Subject: [fw-wiz] help... I have a problem which is actually supposed to be easy--at least according to the Cisco examples, but seems to be giving me fits. I just can't figure out where I'm going wrong. A particular company--being rather, shall we say, posessed of parsimonious pecuniary policies, will not update one of their old PIX firewalls beyond version 4.2. In itself, that's not really too much of an issue. It has three interfaces, and one of them is now to be designated as a DMZ. (This version--although old--of the IOS does indeed handle more than two interfaces) I have set it up according to examples on CCO, and interestingly enough it will work just fine when passing traffic from the outside interface to the DMZ interface. The DMZ is configured for NAT. However, the one thing that has me stumped is why I cannot get it to--through either statics or conduits--communicate with an interface which is of "higher" security level. According to everything I know (which admittedly is not omnicient) this can be done even though by default a "lower" security level interface does not communicate with a "higher" level unless exceptions are made. There are examples on CCO. But it doesn't so far work. I can ping a host on the DMZ, but the host is not actually responding--the PIX does because of a static mapping... Any advice that would be helpful in creating an exception that would allow traffic initiated from the inside interface to the DMZ interface to actually work? Thanks! Michael _______________________________________________ firewall-wizards mailing list firewall-wizards () honor icsalabs com http://honor.icsalabs.com/mailman/listinfo/firewall-wizards _______________________________________________ firewall-wizards mailing list firewall-wizards () honor icsalabs com http://honor.icsalabs.com/mailman/listinfo/firewall-wizards
Current thread:
- help... michael (Feb 17)
- Re: help... Luca Berra (Feb 18)
- <Possible follow-ups>
- RE: help... Claussen, Ken (Feb 19)
