nanog mailing list archives
Re: Hardware question
From: Josh Reynolds via NANOG <nanog () lists nanog org>
Date: Mon, 23 Jun 2025 15:51:38 -0800
My initial thought on this Tom was to actually encourage the OP to use a Mikrotik as the CPE and OpenFlow 1.3 :) Bypass or not, I've seen those fail from too many vendors too many times. It also sounds very expensive to scale out for tons of customers if that's the case (I have an idea it is, and what the OP is doing... probably the same thing I've been working on with a vendor). *Josh Reynolds* joshr () spitwspots com Chief Technology Officer // SPITwSPOTS On Mon, Jun 23, 2025 at 3:46 PM Tom Smyth via NANOG <nanog () lists nanog org> wrote:
Folks Ethernet passthrough devices, that I have seen are ports 11,12 on the Mikrotik RB1100AH , RB1100AHx2 RB1100AHx4, and some Axiomtek devices (Network appliance series can have lan Passthrough with relays that can be enabled or disabled using jumper kits on the mainboard, integrating them in your network requires careful configuration with bridges etc... (normal working vs failsafe working) ... and 2x the ports per Lan bypass group Hope this helps Tom Smyth On Tue, 24 Jun 2025 at 00:15, David Zimmerman via NANOG <nanog () lists nanog org> wrote:Craig, I discovered and used Niagara Networks (nee Interface Masters) for ahalf-decade or so exactly for this purpose — transparent insertion / optical cut-through on power fail, without having to do a passive optical bleed and finger-pointing about light levels. Also gave me extra diagnostic knobs and visibility for the carrier circuit that was passing through it.https://www.niagaranetworks.com/products/network-bypass-switch -dp _______________________________________________ NANOG mailing listhttps://lists.nanog.org/archives/list/nanog () lists nanog org/message/54PKXVLFROIQOY6BHTOVKWYWIYBYGBYJ/ -- Kindest regards, Tom Smyth. _______________________________________________ NANOG mailing list https://lists.nanog.org/archives/list/nanog () lists nanog org/message/LZZ24WAXOPFAY4TZJEFEWRF6GBKU33MI/
_______________________________________________ NANOG mailing list https://lists.nanog.org/archives/list/nanog () lists nanog org/message/HIE2PWIMBM6GLTS3RSSJ5XCAO4Z6VF4X/
Current thread:
- Re: Hardware question, (continued)
- Re: Hardware question Kevin Shymkiw via NANOG (Jun 23)
- Re: Hardware question Mark Tinka via NANOG (Jun 23)
- Re: Hardware question Warren Kumari via NANOG (Jun 23)
- Re: Hardware question Dan Mahoney via NANOG (Jun 23)
- Re: Hardware question Joseph Jackson via NANOG (Jun 23)
- Re: Hardware question Riley O via NANOG (Jun 23)
- Re: Hardware question Stipo via NANOG (Jun 23)
- Re: Hardware question Craig Smith via NANOG (Jun 23)
- Re: Hardware question David Zimmerman via NANOG (Jun 23)
- Re: Hardware question Tom Smyth via NANOG (Jun 23)
- Re: Hardware question Josh Reynolds via NANOG (Jun 23)
